Advertisers assume complete responsibility for their listing(s)
Use of this Web site constitutes acceptance of the HCCA User Agreement.
New Ads On April 29, 2008
1909 Buick Water Pump for Two Cylinder
Engine
I need a gear type brass water pump to
fit a pre-teen two cylinder Buick (1909). Will consider a restorable pump if
in reasonably good condition
Contact:
, Alma WI, 608-685-3116
Gray and Davis Tail Lamp
We are looking for a Gray and Davis
Tail Lamp for our 1908 1 cylinder Cadillac. Due to a rear end collison while
on a tour our present tail lamp is beyond repair. Restored condition prefered
Found in less than One Week on HCCA.org
Contact:
, Castro Valley CA, 510/538-1795
1914or15 Buick 221ci four cylender
engine parts wanted
Im looking for any engine parts for the
buick four cylender engine i think its a 221ci engine what do you have? and
maybe any orther parts as well for that year of car as well,,34 x 4 wood
wheels,,radaitor??
Contact:
, Lakeside CA, 619 871 4021
Single cylinder Cadillac crankshaft
& case or engine around 1903
Crankcase, crankshaft or complete
engine wanted for Model A Cadillac (circa 1903)
Contact:
, Houston TX, 832 830 8083
Needed To Finish 20 Cadillac Model 59
Phaeton
Four windsheild thumb nuts or even
borrow one for a pattern. L.& R. top props. Speedometer driving gear &
shaft located at lower right rear of transmission. Headlamp reflector tilt
cross shaft mechanisim. Mounts on back of radiator. Your help will be
appreciated
Contact:
, Sammamish WA, 425-837-0013
WANTED: Auburn sedan for family touring
(1928-1936)
Seek good original or older restoration
Auburn sedan for family touring
Contact:
, Issaquah WA
Fronty Ford Over Head Cam Engine parts
wanted
I am looking for an original R or SR
Fronty Over Head Cam Engine parts, Side Drive, Water Pump, Water Rail,
Speedway Exhaust, Tower parts, anything even your old broken bits, I can
repair them, anything considered. All help appreciated
There was an ad last week for a 1917
Maxwell frame with engine and a spare engine. Could the person who listed this
ad please contact me please? Also anyone else that may have spare parts for a
1917 Maxwell, please contact me
Contact:
, Trumansburg NY, 607 592 2092
12 Maxwell Messenger parts
I need a radiator and/or shell, door
handle, splash aprons, belly pan,lights, horn, what have you?
Contact:
, ElDorado Ks, 316-320-1947
Headlamp mirror reflector
Outside dimensions: 5 1/2 inches
diameter by about 1 5/16 inches deep. Need one but will buy a pair. Thanks
Contact:
, Huntington Beach Ca, 714-963-6318
Set of 25in. wheels for 1910 Schacht
Need four 25" wheels for a Schacht.
Tire size is 34x4 1/2 Complete or ? This is a high wheeler now, but would like
to change to pneumatic for touring. Hubs not that important, mostly need rims
and spoke's. Thanks
Contact:
, St. Louis Park, Mn., (952) 544-1679
1 cyl car
Unrestored, 1 cylinder car, must be at
least 90% complete, with sound restorable parts.
Contact:
, Wynyard Tasmania Australia
1905 1 cylinder REO
Need motor, transmission, muffler,
water tank and any part to the add on rear seat section. Also need water pump
and spark handle, and new radiator. Serial number 5833
Contact:
, Lewisberry Pa, 717-938-8644
Schebler Model "L" carburetor
or similar
For '12 small 4 cyl Buick. Intake bolt
holes measure 2 3/8" center to center.
Contact:
, South Hero VT, 802-372-6521
bale handle lamps
Will trade a decent lefty for a righty
bale handle side lamps. Unknown maker, no stampings or ID markings
Contact: , Oakdale MN, 651-773-9685
rims / lock rings wanted
24" firestone/goodyear rims and
lock rings for truck wanted, two sets
Contact: , Oakdale MN, 651-773-9685
1901-03 Curved Dash Olds Parts Wanted
Looking for 1901-1903 CDO parts.
Especially front axle, spindles, and flywheel. Also need many other parts.
Original, repro, castings, anything considered. Leads appreciated. Thanks
Contact: , McPherson KS, (620)245-0164
REO Truck crank
Need hand crank for a 1912 Model 'H'
truck. I have a starter mounted on the 1 cylinder engine but would like to
crank it by hand.
Contact: , Seattle WA, 206 367-9383
Wanted 1916 Maxwell Parts
Needing 1916 Maxwell parts, touring
car. Need top irons, hubcaps, wheel puller 23/8x24tpi, steering wheel spider,
various electrical including magneto dash. Mike Also Interested In Other
Projects.
Contact:
, Belleville IL, 618-410-0335
wheels needed
36x5 and 36x12 solid rubber smith
wheels for karavan truck please price and condition and location
Contact:
, camp verde az, 9284514355
Medium Size Brass Tour Car
Reliable, well sorted older restoration
or maintained original. Prefer Hudson or similar 1910-1915 Touring in the
30-40 HP range. Any reasonably priced vehicles will be considered.
Contact:
, Whitehall MI, 231-740-6610
1922 Franklin Series 10 Parts
Wanted: crankshaft, camshaft and
generator timing sprockets (24, 48 and 17 teeth); cylinder head, 5 &
1/4"
diameter at the cooling fins; robe strap and supports; tire pump hose; trouble
light; shades and brackets; trunk and rack. Display: Display my phone number
only
Contact: Bill Charpier, Orangevale CA, 916-987-5845
Hupmobile Model 20
Wanted Hupmobile Model 20. Unrestored
or older restoration. Prefer runabout. All replies answered
Contact:
, Attleboro MA
SEARS REGISTRY for High Wheeled automobiles
SEARS REGISTRY for High Wheelers,
forming a network to exchange information,locate parts & services. Find
out how many are in existence. Year, Model, Serial Number
Contact:
, Cutchogue, N.Y. 516-532-0436
1910 Maxwell Q-4 1911 Maxwell Q-4-11 or !911 Maxwell
GAR
Would consider any 1910 Q-4,1911 Q-4-11
or GAR Maxwell automobiles
Contact:
, Billings Mt
Wanted early 1909 Ford T Rear Axle
Can anyone help me I have a very early
1909 Ford Model T,Engine # 685 and I am looking for the early Babbit bearing
rear axle and the long two piece tail shaft,prepared to pay whatever it takes
to get one.Also need 1909 muffler.Please email t
Contact:
, Neerim Vic, Australia, 61 3 56284403
Wanted Maxwell parts
Needing various parts for a 1916
Maxwell model 25, also have some parts for trade or sale. Needing a wheel
puller, 23/8 ID X 24TPI
Contact:
Mike Lotz, Belleville Il, 618-410-0335
l9l4 Studebaker
Wanted - l9l4 Studebaker Model EB 6
cylinder complete motor or the cast iron cylinder block
I am restoring a 1913 Abbott Detroit
rolling frame to make a speedster, and am looking for any suitable parts and
spares. I would particularly like to find an Abbott-Detroit radiator. Items
from other 1910-1918 models may suit. I am based in the UK but have a shipping
address in Kansas.
Contact:
, Nottingham UK
Hauling to and from Chickasha
Open car trailer 20' 7000# cap. Looking
for loads going to Chickasha. I have some room left on my trailer going but
nothing coming back yet. Leaving Portland Or. area March 15th. We can take
small stuff and or a whole car. Just want to cover the fuel cost. Call Pat
Nash with your needs
Contact:
, oregon city or, 503-319-2785
Non-Skid 34 x 4 1/2 Tires Wanted
Looking for 2 or 4 Non-Skid 34 x 4 1/2
tires for spares, so they don't have to be in great shape
